Because cleaning is the primary function of these machines, this metric accounts for 45% of the total score. The SunJoe SPX 3000 showed a so-so performance during our testing process. Snow Joe® + Sun Joe® may from time to time change the design of its products. Total Stop sun joe spx 3000 System – The motor will shut OFF and remain in standby mode during periods of inactivity, or as soon as the unit is pressurized. THIS IS NORMAL. Simply squeeze the trigger to restart the pump motor. These chemicals will harm the unit and will damage the cleaning surface.
If in the event your efforts are unsatisfactory, please reach out to us directly. To obtain a replacement part or product, please visit snowjoe.com/help or email us at for instructions. Please be sure to register your unit beforehand to speed up this process. Certain products may require a serial number, typically found on the decal affixed to the housing or guard of your product.
This pressure washer features a 34-inch extension spray wand to access hard-to-reach areas, such as 2-story buildings and the undersides of automotive vehicles and lawn equipment. Plus, its rear wheels provide easy portability around your yard. Pressure washer carries and stores two different types of detergent simultaneously in its two 0.9 L onboard, removable detergent tanks.
So, who is the Sun Joe SPX3000 really geared toward? The specs really point toward lighter duty applications. At 1450 psi, cleaning a Champion Power Equipment driveway can be done, but you’ll likely have to keep the nozzle pretty close to the surface, which will narrow your cleaning swath.
In addition to its power, you’ll also want to consider the volume of water produced by an electric pressure washer. While the power tells you how much force the electric pressure washer will use when stripping away dirt, the volume of water tells you about the device’s ability to wash that dirt away. The volume of water is labeled in gallons per minute, or “GPM.” Some models are able to deliver 0.53 gallons per minute, while others deliver 1.76 gallons per minute.
Allow the detergent to remain on the surface for a short time before rinsing with the pressure washer. Do not allow the detergent to dry on the surface. To assemble the spray wand protector, first snap the tab into the slot located at the bottom left side of the unit, and then secure it in place with the remaining small screw (Fig. 8). Never pull the pressure washer by the cord or yank the cord to disconnect it from the receptacle. Keep the cord away from heat, oil, and sharp edges.
The only occasional inconvenience of having to wait on the pump to regain pressure after disengaging the handle. I primarily use the easy to snap on yellow 15 degree spray, nozzle. The green does ok, just slower to rip off the dirt and grime at a wider angle. Glad I went with a higher powered electric unit, as I won’t use it enough to justify a gas unit that would ultimately gum up from only occasional use. I will likely purchase the extension high pressure hose at some point, as it would have been helpful to have a little more room to roam.
Connect the high-pressure hose to the trigger gun (Fig. 10). The following table depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Do not cover or modify the stainless steel lance or the spray nozzles in any way.
Sun Joe has addressed this issue and outfitted both the Sun Joe SPX3000 and the Sun Joe SPX 3001 with a 35 foot power cord to keep you moving without needing to switch outlets. The Sun Joe SPX3000 and SPX 3001 are neck and neck again. If you need to pressure wash tall structures or two story homes, the Sun Joe SPX3000 and the Sun Joe S3001 come equipped with a 34-inch extension spray wand. The former should thus allow you to rinse away dirt and debris with somewhat better efficiency and speed.
Use the 15º fan-tip nozzle for intense cleaning jobs on hard surfaces. Applications include stripping paint, removing oil stains, grease, heavy mildew stains, and rust from steel. This nozzle should only be used in areas that can withstand the high-pressure from this nozzle. Do not make changes to the nozzle while the trigger is engaged. Doing so could result in damage to the pressure washer or injury to the user. NEVER change nozzles without locking the safety lock on the trigger handle.