SUNJOE SPX3000-XT-RM 13A Electric Pressure Washer User Manual

Sun Joe has addressed this issue and outfitted both the Sun Joe SPX3000 and the Sun Joe SPX 3001 with a 35 foot power cord to keep you moving without needing to switch outlets. The Sun Joe SPX3000 and SPX 3001 are neck and neck again. If you need to pressure wash tall structures or two story homes, the Sun Joe SPX3000 and the Sun Joe S3001 come equipped with a 34-inch extension spray wand. The former should thus allow you to rinse away dirt and debris with somewhat better efficiency and speed.

sun joe spx 3000

Another excellent feature is the dual detergent tank. The Sun Joe SPX3000 has two removable tanks that can store different types of detergents to clean dissimilar projects at the same time. Next, turn on the machine for a few seconds until any remaining water leaves the pump, and then switch off the SPX3000 immediately. A potential disadvantage of the SPX3000 is that it doesn’t feature Sun Joe’s pressure select technology. With the Sun Joe SPX4000, for example, you’re able to choose between the LOW/1450 PSI setting and the HIGH/2030 PSI setting depending on how much cleaning power you need.

Prepare the cleaning solution as instructed on the solution bottle. Remove the detergent bottle with foam cannon from the nozzle storage board. Remove the foam cannon cap with detergent suction tube from the detergent bottle.

If it stops working or a part breaks, they will either send you a free replacement part or send you a new or comparable product at no charge. I don’t think I’ve seen another warranty as good on any other product I’ve used in the garden. Four give a different angle and pressure of spray; the fifth is used to apply detergent. The only other pressure washer I’ve used had a canister design, which meant you ended up dragging the canister around behind you.

Connect the high-pressure hose to the trigger gun (Fig. 10). The following table depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Do not cover or modify the stainless steel lance or the spray nozzles in any way.

You can purchase electric pressure washers with varying levels of power, depending on the types of jobs you think you’ll be doing most often. They range from being able to tackle heavy-duty, commercial-grade jobs to helping you clean the summer’s dirt and dust off your patio furniture. The Sun Joe Pressure Washer has a trigger lock to keep the spray wand from spraying accidentally, Champion Power Equipment which could damage some surfaces or injure someone if hit with the high-pressure spray up close. You should engage the lock when changing nozzles or really at any time that you aren’t actively using the spray wand. You should also be careful to keep the power cord out of the water as you’re working. Works well at close range for those dirtiest of steps and sidewalks.

Allow the detergent to remain on the surface for a short time before rinsing with the pressure washer. Do not allow the detergent to dry on the surface. To assemble the spray wand protector, first snap the tab into the slot located at the bottom left side of the unit, and then secure it in place with the remaining small screw (Fig. 8). Never pull the pressure washer by the cord or yank the cord to disconnect it from the receptacle. Keep the cord away from heat, oil, and sharp edges.

If in the event your efforts are unsatisfactory, please reach out to us directly. To obtain a replacement part or product, please visit snowjoe.com/help or email us at for instructions. Please be sure to register your unit beforehand to speed up this process. Certain products may require a serial number, typically found on the decal affixed to the housing or guard of your product.