I also cannot stress enough that Intex metal-frame pools must be set-up on ground that is extremely level and that attaining this may require extra work and costs. To test the pool’s resilience, we let a line of rambunctious kids hop in and out and back in again, day after day. A 70-pound child who wasn’t quite tall enough to step over the side to get into the water kept hurling herself up and over, often catching a piece of the frame on her foot. She even bounced while sitting on the side at one point—which, looking back was perhaps not the safest move, and we wouldn’t recommend—but still, she didn’t warp or damage any of the pieces. Intended to be assembled and then maintained in place for extended periods of time, Intex metal-frame pools lend themselves to the concept that you can obtain the benefits of an installed swimming pool without the pricey expense of one.
A small gap will be required at the top of the bucket opening so that the pump can pull the DE into the filter system. Care for your Intex pool properly to enjoy swimming in crystal clear water all summer long. During winter, the brand recommends draining, disassembling, and storing the pieces in a safe location. To drain, remove the cap from the valve on the exterior pool wall and hook up a hose. I’m also not super thrilled that the cover Intex sells as an accessory, blows off in the slightest of winds; a problem if you don’t want to clean leaves and bugs out of your pool each day. However, the kids didn’t listen to me and yet the pool stood firm.
The same goes for the liner—we needed one person to hold the heavy-duty pool liner up while the other person slid the metal beams through the liner sleeves. As expected given the minimal amount of parts in the box, setup was essentially snap-and-go. All it took was two people, some patience, and some elbow grease—we didn’t even need the DVD to get intex purespa the frame built. I spent the first hours that the kids were in the pool, yelling at them not to bump into the pool walls or create too many waves; I was sure it was going to explode and wash them out into the yard. This 12-foot by 30-inch round Intex pool was the perfect fit for this family. Owning a swimming pool has always been a dream of mine.
It managed to combat the constant influx of dirt and grime from little feet jumping in and out of the pool. Our younger ones refused to wear flip flops when walking to or from the pool, so they gave this filtration system a run for its money between the bits of grass, leaves, and dirt stuck to their feet. Even with that influx of grime, the water turned from cloudy to clear every time we ran the pump.
However, my husband did not share in my joy as he was fully convinced that assembling it would be a weekend-long project that would end with me in tears and him in frustration. According to everything I have read the Intex frame pool will collapse no matter you do. Everything I read says the ground has to PERFECTLY level or it will collapse. So in other words If you buy one it is going to collapse sooner or later anyways.
Once that was done, we simply snapped together the hard plastic support pieces of the frame with the metal ones and secured it with the thick band to give the framework a little bit of extra security against rambunctious kids. The paper instructions were plenty sufficient to get the job done, and it took less than half an hour from start intex frame pool to finish. We let a line of rambunctious kids hop in and out and back in again, day after day. In order to get the main part of the frame built, we had to pin the side supports in the corners and then pin the beams, which only works if you have one person pinning while the other person is holding the pieces in place on the opposite end.